Peening Jig H.V.F.

Please do not use the scythe peening hammer with this jig. Use regular hammer instead. The ideal hammer weight to use is 600-800 g.

With narrow anvil and peening hammer, one has more peening flexibility and it is possible to produce finer edge. It, however, requires more practice and skill. Anyone can learn to use this jig almost instantly and your scythe or sickle will be ready to mow in few minutes. Depending on your land and grass condition, it is recommended to peen your scythe every 3 to 5 hours of mowing. 

Directions:

Attach the peening jig body to a bench or wood chock. Pre-drill the hole to prevent wood cracking and to fit tightly at the same time. Never use metal material to tap the jig body to the chock or bench. Use wooden mallet or hammer with piece of wood to protect the metal.

1st pass: To "pull" the edge, use the red hat with one stripe. Insert the scythe blade between the jig body and the hat so that the edge is touching the central tenon. We peen from the heel side of the scythe by overlapping blows. With the right amount of hand pressure and hammer blow, the scythe moves along the edge almost automatically. The scythe should rest on the body with the same side up as while mowing - with the tang and tang knob pointing upwards.

2nd pass: change the caps. Use double striped yellow cap and repeat the process. If the scythe edge is still sufficiently thin, you don't have to use the first cap every time when peening the scythe.

After the second pass, use the carborundum coarse stone to finish the edge: use the rounded stone edge and the scythe rib as your guide to gently sharpen the edge.

Once finished, you should be able to use finer stones (e.g. Rozsutec) while mowing. The blue shale stone is too fine and will not work with the peening jig.